Source Editor : "Right-Click : Source -> Add Unit To Uses Section", failed to add unit into "Interface" section
Original Reporter info from Mantis: takeda99
-
Reporter name: Takeda Matsuki
Original Reporter info from Mantis: takeda99
- Reporter name: Takeda Matsuki
Description:
When I tried to add any units into "Interface" section from "UseUnitDlg" by using Double-Click or Press "OK" button was failed but when I tried to add any units into "Implementation" section it works.
Well, Everything is working normally and this issue not come until the changes/rev 37310. After 37310 Case "Source Editor : Right-Click : Source -> Add Unit To Uses Section" always come. The problem is I can't add any units from "UseUnitDlg" into "Interface" option section.
I thought this issue come from 37310, when "SourceEditor.pp" using "LazLoggerBase". I tested to remove/disable "LazLoggerBase" from "sourceeditor" recent r37407 (like I did in "sourceditor.pp" file attached), everything back to normal, I could add any units to "Interface" section.
I build IDE using "-O2 -g- -Xs" ("Optimized IDE" Profile) both for Compilation first-time and Rebuild the IDE, also I using Clean-Up mode : "Clean All".
My Shortcut : "C:\Laz-RAD\RAD-w27\lazarus.exe --primary-config-path=C:\Laz-RAD\RAD-w27\Z-Cfg-w27"
Regards,
Takeda.
Additional information:
This issue part of issue 22102 ( http://bugs.freepascal.org/view.php?id=22102 )
I use Windows 7 Ultimate (64bit).
Mantis conversion info:
- Mantis ID: 22114
- Version: 1.1 (SVN)
- Fixed in revision: r37422 (#48d4107e)